Whirlpool cabrio problems f1

What does f1 mean on my Whirlpool Cabrio washer?

The Cabrio Washer F1 error code happens when the main control board gets a bad signal from the water level pressure switch circuit. This is normally caused by a pinched or ripped water level pressure switch hose.

How do I fix f1 error on Whirlpool Cabrio?

When the Whirlpool Cabrio displays an F1 error , this means the the control board is having difficulty communicating with the motor. To fix your F1 error , you can first try to unplug your washing machine for 15 minutes and then plug it back in. If this doesn’t work, you will need to replace the control board.

What does f1 on my dryer mean?

The ” F1 ” error means that the dryer’s thermistor failed. The dryer is reading the thermistor as “open” and the actual part has shorted out. The thermistor is used to read and control temperatures within the dryer .

How do you reset a Whirlpool Cabrio?

Try the Cabrio Reset Procedure Touch any button that you see on your display pad. This will clear the error code. Or you can press PAUSE/CANCEL. Choose a cycle and press START.

How do I know if my washing machine control board is bad?

A failed front-load washing machine control board has several symptoms, including the washer not starting, filling, spinning or draining.

Does Whirlpool still make Cabrio?

The Whirlpool brand, maker of the Duet and Cabrio model, is a leader in washer and dryer sales in the United States. However, as with any appliance, there can be problems and a need for repairs. When your Cabrio stops working, Whirlpool offers troubleshooting tips online along with other product information.

You might be interested:  Italian f1 drivers

How do I fix f1 error in AC?

The error code ‘ F1 ‘ means the indoor unit PCB and outdoor unit PCB cannot communicate with each other. To fix the problem you can do the following: Check all connections are clean and tight. Corrosion on connections can cause this error , use light abrasive paper to clean each one.

How do I fix f01 error?

The F01 indicates a failed electronic machine control board. This error code can sometimes be caused by a glitch or power surge through the electrical lines. You may be able to clear this code by unplugging the washer for 5 minutes.

What does f3 mean on a Whirlpool dryer?

not heating

What does e1 mean on a Whirlpool dryer?

The Whirlpool Duet Dryer Error E1 means the control has detected that the thermistor is open. This error can be a wiring issue from the control to the thermistor or a bad thermistor.

How do I run a diagnostic on my Whirlpool washer?

Whirlpool Duet Diagnostic Test Mode Close the washer door. Select any one key except “Stop/Cancel” and Control Lock. Using the same key If you got it right all the lights on the Duet washer’s control should light up, and any error codes in the washer’s memory will be displayed.

How do I reset my Whirlpool top load washer?

How do I reset my Whirlpool washing machine ? Unplug the washer for 1 minute from the electrical outlet. Plug the washer back in and lift and lower the lid 6 times within a 12 second period. You have 30 seconds to start lifting and lowering the lid. The motor has now been reset and is ready for you to start a cycle.

You might be interested:  Bakflip f1 review

Why won’t my Cabrio washer fill with water?

If you find your Whirlpool Cabrio washer not filling with water , the inlet hoses and screens may be at fault. Metal screens attached to both ends of the inlet hoses protect the water inlet valve from sediment and debris. To inspect the screens for signs of clogging, turn off the main water supply.